Reely TQ Performance Drone RtF, Руководство по эксплуатации

Страница: 18 / 32

18
f) Practical flight tips for the first start
Although the model can be flown in a very confined space, we recommend using an unobstructed space of approx.
3 x 3 m for the first flight attempts.
Place yourself directly behind your quadrocopter. For as long as the tail with the green LED is pointing towards you,
and you see your model from behind, it will respond from your perspective to the right, left, forward and backward
control commands just as you see it. However, if your model has its front towards you, it will react in the opposite way
to the steering commands on the transmitter from your perspective.
Caution, important!
Never try to grab hold of the flying quadrocopter with your hands. There is an increased risk of injury!
When the two quadrocopter LEDs start to flash, the quadrocopter rechargeable battery has reached its lower voltage
limit. In this case, stop the flight operation immediately and recharge the quadrocopter rechargeable battery in order
to avoid deep discharge that can damage the quadrocopter rechargeable battery.
Never switch the transmitter off while the quadrocopter is flying. If the quadrocopter moves too far from the transmitter
and receives no more IR control signals, it will land automatically.
g) Quadrocopter take-off
To start the quadrocopter, proceed as follows:
Switch on the transmitter and the quadrocopter as described above. The transmitter LED and the two quadrocopter
LEDs must glow steadily.
If you now move the joystick for the pitch and yaw function (see Figure 1, no. 9) slightly forward and then back to the
middle position, the rotors will start and rotate at idle speed.
If you now move the joystick for the pitch and yaw function again slightly forward and then back to the middle position,
the quadrocopter will start and move upwards approx. 1 m. The reachable flight altitude during the start depends on
the current charge level of the quadrocopter rechargeable battery.
The quadrocopter can automatically maintain the flight altitude due to its barometer function.
You can now further control the quadrocopter using to the control commands described above.
h) Landing the quadrocopter
To land the quadrocopter, first steer it over the planned landing site. Then reduce the flight altitude until the quadro -
copter comes into contact with the landing site.
Then move the joystick for the pitch and yaw function to the lowest position until the rotors power off.
Then disconnect the quadrocopter rechargeable battery and only then switch off the transmitter.