Reely 1400004, Руководство по эксплуатации

Страница: 23 / 60

23
b) Inserting the Flight Battery into the Quadrocopter
To ensure a sufficiently good satellite reception, the quadrocopter should be set up on a free field, where no high-
voltage lines, power masts, metal constructions or other obstacles may impair GPS reception.
Stay away from broadcasting systems and other facilities that may negatively influence the electromagnetic conditions
in your environment.
The flight field should also be free of obstacles such as buildings or trees to ensure unimpaired flight operation.
Choose a day with good whether and the least possible wind.
Before inserting the flight battery in the quadrocopter, check the voltage situation. For this, briefly push the on/off
button (1) at the flight battery. All four LEDs must be lit for two seconds.
Switch on the remote control transmitter and check the correct function of the transmitter with the display. The trim-
ming displays (see figure 10, items 5, 6, 8 and 10) must be in the middle position. If this is not the case, the trimming
must be set (see the following chapter 11. g).
Turn the rotating encoder „VRB“ to the centre position or check the centre position of the controller.
Now push the deactivated flight battery (see figure 16, item 1) into the quadrocopter with the charge connection con-
tacts first. Slightly push the grooved surface of the battery lock (see figure 16, item 2) so that the locking tab can latch
and the flight battery is safely held in the quadrocopter.
When the flight battery has been inserted into the quadrocopter and is locked properly, switch on the flight battery with
the on/off button (see figure 6, item 1), so that the quadrocopter is supplied with power
Figure 16
The status LEDs (see figure 16, item 3) light up yellow (red and green) and the quadrocopter performs a self-test. After
a brief time, the downward-pointing LEDs in the book arms will flash and the quadrocopter will emit a brief signal.
The gimbal swivels the camera holder into the home position and the status LEDs will briefly go out and then start to
flash. The meaning of the flashing impulses is described in more detail below.
When the binding between the transmitter and receiver is correct, the display of the remote control shows the voltage
supply of the receiver (see figure 10, item 4). Push the buttons „UP“ or „DOWN“ at the transmitter to get more infor-
mation about the current reception of the GPS satellite.