11
Attention!
If you still use a mechanical speed controller that has a BEC transmitter, it must not be used to supply the
receiver with power. The voltage pending at this plug is too high.
Instead, use a separate voltage source with four batteries or a 4- to 5-cell receiver battery.
Switch the transmitter on and then take the receiver into operation. If transmitter and receiver are bound correctly
(usually set ex works) the red control LED in the receiver lights up (see figure 5, item 16). Verify correct function of the
receiver and the connected servos and then switch it off again.
b) Installing the Receiver
Installation of the receiver depends on the model. For this reason, you should always follow the recommendations of
the model manufacturer regarding the installation.
Regardless of the model, you should always try to install the receiver so that it is protected from dust, dirt, moisture,
heat and vibration in the best possible way. Two-sided adhesive foam (servo tape) or rubber rings that hold the foam-
wrapped receiver securely in place are suitable for fastening.
Attention!
The aerial wire (1) length is determined precisely.
For this reason, you must not roll up the wire, place it
in a loop or cut it off. This would decrease the range
significantly and thus pose a considerable safety risk.
Route the aerial wire out of the mode through an
opening in the fuselage. Best use the aerial tube en
-
closed with the remote control for this.
Figure 7
