Series L 70000 Spring Driven Cord Reels
www.reelcraft.com
Page 3
Replacing the Output Cord/Work Device (figure A)
WARNING:
Remove power from reel before performing any of the following proce-
dures.
Use extreme caution, reel under tension. Avoid releasing latch
mechanism.
1. Pull output electrical cord from reel until fully extended, then latch.
2. Remove output bumper stop (3).
3. Remove access cover (1).
4. Disconnect output electrical cord/work device (4) at terminal strip
(2).
5. Remove cable clamp.
6. Remove strain relief (5). Remove output electrical cord/work
device.
7. Install replacement electrical cord/work device by reversing steps
2 through 5.
8. Release latch and rewind electrical cord on reel.
9. Replace access cover (1) and bumper stop (3).
Replacing the Input Cord (figure A)
WARNING:
All cord reels with GFCI receptacles must be hard wired into the electri-
cal circuits. Use of 2 or 3 prong plugs may cause a potential
malfunction of the GFCI receptacle.
1. Remove access cover (1).
2. Remove wire nuts (6) securing input electrical cord to collector
assembly (7).
3. Remove zip tie (not pictured), being careful to not damage wires.
4. Remove 90 degree elbow (8).
5. Remove input electrical cord.
6. Remove 11” of outer jacket from replacement input electrical cord
(input electrical cord wires must protrude a minimum of 6” from
center of collector assembly).
7. Install replacement input electrical cord by reversing steps 1
through 4.
8. Replace access cover (1).
Replacing the Brush Holder/Brushes (figure A)
1. At terminal strip (2), remove wires connecting brushes (9) to ter-
minal strip.
2. Remove lock nuts (10) securing brush holder (11) to reel. Relocate
cable clamp temporarily and remove brush holder.
3. Remove brushes (12) from brush holder (11).
4. Install replacement brush holder/brushes by reversing steps 1
through Upon completion of installation, adjust brush-to-ring
alignment by loosening nuts (13) and sliding finger assembly
(14).
1
14
10
12
13
11
3
5
8
2
9
4
7
15
6
Figure A
