Reelcraft Industries, Inc. • (800) 444-3134 / (260) 248-8188 • Fax: (260) 248-2605
[email protected] • www.reelcraft.com
Figure 16
Figure 14
Figure 15
Figure 13
Step 10:
Attach the battery box support and strap clamps to
the trailer as shown in figure 14. Locate the
accessory pack that is attached to underside of the
battery box cover. Discard the flat head sheet metal
screws supplied with the strap clamps. Use the
supplied 10-32 x 3/4” long round head machine
screws, and 10-32 nuts. See figure 15 for assembly
details. Tighten the screws after assembly.
Step 11:
Attach the battery box to the trailer as shown in
figure 16. As an alternative, the power for the reel
may be supplied by the tow vehicle. Run the
“battery” wires from the electrical switch of the reel
to the 12 volt battery of the tow vehicle. Use the
supplied electrical connector at the hitch of the
trailer. Be sure to properly secure the wires to
prevent them from dragging on the ground. Route
the strap under the clamp opening as shown in
figure 17. Make sure the buckle is positioned
properly on the top. Place the battery box in the
battery tray. Insert the battery (not supplied). Place
the battery box cover on top of the battery box, and
secure with the strap as shown in figure 18. See the
following page for instructions to wire the switch
and battery of the trailer.
Figure 17
Figure 18
6
