The Quasar Pro charger is a competition charger and is supplied with alligator clip
leads for the output harness. The red alligator clip connects to the positive (+)
connection on the battery. The black connects to the negative (-).
Connect the battery pack to be charged to the alligator clips protruding from
the front of the charger.
Plugging in/hooking up backward may severely damage the charger
and battery.
The early versions of Ni-MH batteries tend to false peak during the first
ten minutes of the charging cycle. If you are charging this type of
battery pack, it is recommended you monitor the charge during the first
ten minutes. If the charger shuts off during that period and the pack is
at room temperature, push the ENTER button to resume charging.
CHARGING
WARNING!
WARNING!
OPERATIONAL MODES
When turning the charger on, if you are not going to change any of the programmed
settings, you may go directly into one of the operational modes. You can then select
desired mode by procedure listed below.
Turn on the charger and connect the battery to the charger. One of the following
screens will read:
Use Up or Down buttons to select desired operating mode. Screen will display selected
mode and start command.
Push ENTER button. Charger will automatically start in the selected mode.
The charger may be stopped at any time in any of the operational modes by pushing
the BACK/SETUP button.
CYCLE MODE XTIME
CHARGER MODE
DISCHARGE MODE
5
Connect black to the negative end and
red to the positive end
1
2
