REED R8060, Инструкция по эксплуатации, Страница: 6 / 12

6
Operating Instructions
1. Turn the meter on by pressing the Power Button.
2. Press the Time Weighting Button to select the desired Response
Time. If the sound source consists of short bursts, set the response
to FAST. To measure average sound level, select SLOW.
3. Press the Frequency Weighting Button to select the Frequency.
Select "A" Weighting for a general noise sound level, or "C"
Weighting for measuring high level noise. "C" Weighting is a stan-
dard weighting of the audible frequencies commonly used for the
measurement of Peak Sound Pressure Level. If the "C" Weighted
level is much higher than the "A" Weighted level, then there will be a
large amount of low-frequency noise.
4. Press the UP and DOWN arrows to select the desired dB range.
Choose a dB range in which the measured level is registering
approximately in the middle of the bar graph. If the over range
indicator appears during your measurement, the upper limit of the
selected dB range has been exceeded. Adjust the selected dB range
until the over range indicator disappears from the screen. Further-
more, if the under range indicator appears during your measurement,
the lower limit of the selected dB range is too high to register your
measurement. Adjust the selected dB range until the under range
indicator disappears.
5. Hold the instrument comfortably in one hand (away from your body)
or position it on a tripod for long-term monitoring. Point the micro-
phone in the direction of the noise to take a measurement.
NOTE : Direct contact with strong winds or blowing air on the microphone
may cause measurement errors. These effects can be reduced by using
the included windscreen.
MIN/MAX Hold
Press the MIN/MAX Hold button to display the Maximum and Minimum
sound level values recorded during the measurement process.
1. Press the MIN/MAX Hold Button once to display the maximum value.
2. Press the button again to display the minimum value.
3. Press and hold the button once more to resume normal operation.
continued...
www. .com
information@itm.com 1.800.561.8187