9
General Setup
1.
Set the required Temperature unit of measure by tapping on the circle
next to °F or °C.
2.
Set the Alarm ON or OFF by tapping on the toggle switch.
3.
To set the HIGH and LOW Alarm thresholds for temperature, humidity
and CO
2
, open the numerical keypad by tapping the small arrow to
the right of each alarm programming field. (Alarm must be enabled)
4.
Tap
SAVE
to confirm your settings or tap on the
X
to cancel and
resume normal operation.
Note:
At any time, you can tap on the
X
to exit the Setup mode and
resume normal operation.
Recording Setup
The sampling rate can be set from "1" second to 23 hours, 59 minutes
and 59 seconds.
1.
To set the sampling rate, open the interactive numerical keypad by
tapping the required hours, minutes, and seconds sampling
rate fields.
2.
To enable or disable a scheduled recording tap on the toggle switch.
3.
To set a recording start time, open the interactive calendar by
tapping the small arrow to the right of the programming field.
(Scheduled recording must be enabled)
Note:
The default start time is the current system date and time.
continued...
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
