14
Manual Data Logging Mode
In manual mode the
LOGGER
button is pressed to manually log a reading
on the inserted SD card at any time. In order to setup the meter for
manual data logging, follow steps 1 through 8 below.
1. Set the data logging sampling rate to '0' seconds.
2. Press the
REC
button to enter manual data logging mode.
3. "REC" will appear on the LCD as well as P-x (x = memory position
number between 1 and 99).
4. Press the
SET
button to set the desired memory position.
5. Use the and buttons to select one of the 99 data memory positions
in which to record.
6. Press the
ENTER
button to confirm the selection. Repeat steps 4 to
6 for every selection.
7. Press the
LOGGER
button to save a reading to memory. "LOGGER"
will flash each time a data point is stored.
8. To exit manual data logging mode, press and hold the
REC
button
2 seconds to resume normal operation.
Note:
The meter will scan for a SD memory card when a first manual
recording is attempted. If a card is not inserted or the card is defective,
the meter will flash CArD-E-. In this case, power the meter OFF and try
again with another SD memory card.
Automatic Data Logging Mode
In automatic mode the desired data logging sampling rate is set to 1, 2,
5, 10, 30, 60, 120, 300, 600, 1800 or 3600 seconds prior to recording.
In order to setup the meter for automatic data logging, follow steps 1
through 5 below.
1. Press the
REC
button and "REC" will appear on the LCD.
2. Press the
LOGGER
button to enter automatic data logging mode.
3. The "REC" icon will continuously flash while the "LOGGER" will flash
every time a reading is stored at the user selected sampling rate.
4. To pause the data logging session press the
LOGGER
button and
both the
REC
&
LOGGER
buttons will stop flashing. To resume press
the
LOGGER
button again.
continued...
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
