12
www.REEDINSTRUMENTS.com
Adjusting Emissivity
The instrument's emissivity can be adjusted from 0.01 to 1.0 to meet the
type of surface being measured. Refer to the
Emissivity Chart
for refer-
ence. Press the
SET
button three times to enter the emissivity setup. Press
the
button to toggle between emissivity preset values as indicated by
P1-P5. Use the
UP
and
DOWN
buttons to set the emissivity values. Press
the
UP
and
DOWN
buttons to add or subtract 0.01 unit and/or hold the
UP
and
DOWN
buttons to add or subtract 0.1. The instrument will exit the
setup after 10 seconds of inactivity or if the trigger is pulled at any time.
Switching the Unit of Measure (°F/°C)
Press the
SET
button four times to enter unit of measure setup. Use the
UP
and
DOWN
buttons to switch between °F and °C units. The instrument will exit
the setup after 10 seconds of inactivity or if the trigger is pulled at any time.
continued...
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
