Disclaimer Products in this specification manual must by regulation be installed by licensed and
registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete
models from their range without prior notification. Dimensions and set-outs listed are correct at time of
publication however the manufacturer/distributor takes no responsibility for printing errors.
VADA
TWIN MOTOR MACERATOR
FIG 1
FIG 3
Connecting incoming waste water:
1. Connect the first waste line by cutting off the seal cap at the top of
the unit with either a stanley knife or hacksaw.
2. Connect the rubber connector to the outlet and tighten with a metal
hose clamp (Fig 1).
3. Connect the remaining inlets via the diagrams in Fig 3.
4. To connect the 100/110 incoming waste water, remove the plug
from the side inlets and fix the sleeve in place using a collar. Fully
insert the 100/110 pipe in the other end of sleeve and fix in place
with a clamp.
Ø 40/50mm
27 cm
min
FIG 2
page 4 of 7
