7
2. Identify the Right Upright (92), which is marked
with a “Right” sticker.
Have a second person hold the Right Upright
(92) near the Right Base Cover (102).
See the
inset drawing.
Tie the wire tie in the lower end
of the Right Upright securely around the Upright
Wire (93). Then, pull the other end of the wire tie
out of the upper end of the Right Upright until
the Upright Wire is routed completely through
the Right Upright.
Gently pull up on the Upright Wire (93) as you
set the Right Upright (92) on the Base (103) in-
side the Right Base Cover (102).
Be careful not
to pinch the Upright Wire.
Attach the Right Upright (92) to the Base (103)
with two 3/8" x 3 3/4" Patch Bolts (5) and two
3/8" Star Washers (6). Note: It may be neces-
sary to tip the top of the Right Upright forward
slightly as you thread the Patch Bolts into it.
Do
not tighten the Patch Bolts yet.
Attach the Left Upright (91) in the same way.
Note: There are no wires on the left side.
103
93
102
2
92
6
5
91
93
92
Wire
Tie
Wire
Tie
3. With the help of a second person, lower the
treadmill off the cardboard stand. The stand will
be used again in assembly step 9.
Identify the Left Upright Sleeve (89) and the
Right Upright Sleeve (90); the Upright Sleeves
are labeled “Left” and “Right.” Slide the Left
Upright Sleeve onto the Left Upright (91), and
slide the Right Upright Sleeve onto the Right
Upright (92).
89
“Right”
Cardboard
Stand
“Left”
90
3
92
91
