6
GettGetting started
The device needs to be hooked up to a 12-Volt power source (either a battery or our CV4501 power supply)
Follow these few simple steps to get started:
Hook up an air line with an emergency glad hand to the emergency outlet (red) of the device.
Hook up an air line with a service glad hand to the service outlet (blue) of the device.
Hook up a standard 7-wire power cord to the 7-way socket.
Put an air fitting to the air input of the device and hook up shop air to it.
Hook up the emergency and service glad hands and the 7-way power cord to the trailer.
You are ready to start using the device.
Programming a remote control
A remote control can be programmed very quickly in a few easy steps.
15-function remote
Make sure the device is turned off
Press and hold the ON/OFF button on the control panel for approximately 5 seconds until the ON/OFF
light starts to blink.
Release the ON/OFF button
Press the red button (PROG) on the remote and release
The remote is now programmed
Special function of remote
Function #3 et #4 : Flasher constant or blinking
The device came normally programmed with the output of the flasher activated constantly. If you want to have that
output to flash, you have to press and hold the #3 or #4 for 5 second. You will witness the difference with the
activation of the output flashing and the light on the trailerteck will blink. You will hear the buzzer if this option is
activated. To come back at a constant output, you have to press and hold the #3 or #4 for 5 second again.
Function #6 : standard brake light or Electrical brakes
To activate the electrical brake function, you must press and hold the button #6 for 10 seconds. You will witness
the activation of the electrical brake once the brake light on the Trailteck starts blinking. The output current will go
down a bit to permit the activation of the electrical brake system
Function alarm
Hold for 5 seconds to activate/deactivate the audible signal coming from the device when a remote function is
activated
Function Freeze
.
For safety purposes. Hold 5 seconds to freeze /unfreeze the remote and the device. When the remote and the
device are frozen, all the functions activated will stay activated but no other functions can be applied
