NOTE: Only applicable for 4 door Jeep.
Step 3.
Place a supplied M8x1.25x30mm button head bolt with
supplied M8 flat washer (G) and supplied M8 split washer
(H) through the hole in the bracket through the hole in the
hood hinge onto factory hood. Repeat step for remaining
bolt. Once all hardware is installed tighten down all
hardware. Repeat step 1-3 for remaining bracket.
Page 2
Step 1.
Using a T-50 torx bit locate and remove two factory bolts
on the hood. Discard factory hardware.
INSTALLING BRACKET ON HOOD HINGE
Step 1.
Using a T-50 torx bit locate and remove two factory bolts
on the door hinge. Discard factory hardware.
Step 2.
Place supplied mounting bracket (A) onto Jeep. Line up
the bracket holes with the holes in the hood hinge holes.
INSTALLING BRACKET ON REAR DOOR HINGE
