6
Schematic Diagram
7
Fixing the unit to the wall
•
Suitable screws and washers must be used through the designated keyholes on the backplate of
the unit ensuring the unit securely fastened to the wall.
•
Ensure the fixing screws are horizontal and the unit, when installed, is level.
Connecting the water supply and vent pipes
•
When the unit is fixed to the wall, make the final water supply and steam vent connections and
secure the pipework.
•
Switch the water supply back on.
Connecting the mains cable
•
Ensure the mains supply is isolated.
•
Connect the mains cable from the unit to the means for disconnection (eg. 13A fused double pole
isolating switch).
•
Ensure the cable clamps are firmly secured and the cable ends are tightened into the terminal
block.
Note:
The supply cable must be a minimum of 1.0mm² 3-Core multi-strand PVC insulated mains
cable. The terminal block will not accept cable diameters above 1.5mm².
Check that the mains supply matches the electrical rating on the product.
The rating plate is located on the bottom edge of the unit.
IMPORTANT:
Connect the supply cable, complying with BS.6500, to this appliance in accordance with the
following code:
GREEN AND YELLOW (EARTH) connect to the terminal marked “ ” .
BLUE (NEUTRAL) connect to terminal marked “N”.
BROWN (LIVE) connect to terminal marked “L”.
WARNING: THIS APPLIANCE, AND ALL METAL PIPEWORK CONNECTED TO IT,
MUST BE EARTHED.
Replacing the front cover
•
Support the front cover and re-attach the neon light carefully clipping to the unit.
•
Replace the front cover and secure using the top and bottom screws.
•
Apply Teflon tape to tap thread and screw-in.
•
Reconnect the mains water supply.
•
Check for any leaks and make good prior to turning mains electricity supply on.
