The mouse may lost connection with the USB receiver for some occasional reasons such as strong
magnet, violent vibration. So you may need to reconnect the mouse with the USB receiver. In this case,
unplug the receiver and plug it back again. Slide the power switch on the bottom of the mouse to ON,
press and hold the Left, Middle and Right button at the same time till the scroll wheel lights up and flash
in yellow. It will flash for about twenty seconds and then change back to the previous light effect . The
reconnection will be completed and you can use the mouse then.
Features:
Auto Sleep and Smart Shutdown
The mouse will sleep in eight minutes if there is no operation or when you shut down the
computer or unplug the USB receiver. You can wake it up by clicking any mouse button
except the DPI+ and DPI- buttons.
5 DPI level with indicator
Press DPI+ and DPI- button can be switch mouse DPI level among
1000(Red)/2000(Blue)/4000(Green)/8000(Yellow)/16000(Orange) , defaulted as 1000DPI
Low Battery Indication
The scroll wheel light will flash in yellow when battery is low.
Backlight Effects (set via software)
LED Effects: Steady ON, Respiration, Streaming, OFF.
Storage for the Nano USB Receiver
The nano USB receiver can be stored in the storage slot on the bottom of the mouse.
Software Instructions
Please download the software on
www.redragonzone.com
for this mouse. You can get
more functions and settings after software installation.
1.
The DPI value can be set
from 100 to 16000DPI.
2.
Continuous keystroke function: Set the number of clicks and delay time.
3. Backlight mode of the side edge: Steady ON/ Respiration/Streaming/OFF.
4. 10 of the mouse buttons can be remapped to various actions.
5. Polling rate: 125Hz/250Hz/500Hz/1000Hz. As default, working mode 1 was set to
125Hz and working mode 2 was set to 1000Hz.
6.
For each of the two working modes, the mouse buttons can be set independently.
7.
Battery percentage indication: Battery percentage information is shown on the
main interface of software.
