RMB-M621/3
9
GBR
II. OPERATION
WARNING! Parts of the device may become extremely hot when operating. Keep out of
reach of children.
Replacement of the removable metal plates
1. Open the main lid.
2. Push back the plate lock on the housing of the appliance and remove the metal
plate. Repeat the action with other plate.
3. Push the lock back and install the selected plate into the device so that the
projections on it aligned with the slots on the housing. Release the lock. Repeat
the action with other plate.
NOTE! Be sure to push the lock back before installing the removable plate, do not press
on it! Installing the plate forcefully can lead to lock breakage!
DO NOT replace the metal plates if the appliance is plugged in.
Use of the appliance
The device must not be used without the plates installed.
1. Plug in the appliance. The power light and heat indicator light will be lit. When
the device reaches the required temperature, the heat indicator light will turn
off.
To get the best result possible, place food inside when the heat indicator light is switched
off!
Food must be frozen.
Do not use products that contain a large amount of water, remove any excess
moisture before cooking. A large amount of water being released from the product
may lead to overheating and device failure.
2. Open the lid of the appliance. Depending on the type of adjusted plates put in-
gredients for sandwiches, the dough for waffles or products for cooking on a grill
onto the lower heating surface (meat, vegetables, etc.). Ensure the plates are not
overfilled.
Non-stick plate coating allows to cook without oil. However, you may apply a small
amount of vegetable oil or butter to plate working surface if desired.
3. Press products with the upper plate, lock the device.
NOTE! Do not apply too much force, it may lead to breakage! If the size of the
product exceeds the capacity of the plates, reduce the serving.
4. The heating indicator will be occasionally lit up during cooking. The cooking
time is defined by the type of product and your taste.
When cooking some food, residues of fat / oil or liquid ingredients may leak under
-
neath the appliance panels. This is not a malfunction. If this happens, place a paper
towel under the access holes in the lower part of the device.
5. Open the lid of the appliance after a while. Remove the ready dish using wood-
en or silicone paddles.
6. Unplug the appliance at the end of operation. Clean the appliance according to
recommendations of the section "Cleaning and maintenance".
III. COOKING TIPS
Common Cooking Mistakes and Ways of Solving Them
This table familiarizes you with the practical tips and solutions to some common
problems you may experience when using the multibakers.
THE TOP OF THE PRODUCT IS BAKED THROUGH WORSE THAN ITS BOTTOM
Possible causes
Solutions
The product has been laid for too
long
For uniform baking on both sides add the pro-
ducts quickly and immediately close the multi-
baker
The multibaker was opened during
cooking
Do not open the lid of the appliance while coo-
king earlier than recommended
Not enough ingredients
Add more
Pastry prepared incorrectly
Follow cooking recommendations
THE DISH IS UNDERCOOKED
The dish is cooked with the open lid
Cook with the closed lid
