RedMax RMS-EX600, Руководство оператора

Страница: 7 / 28

Operation
To start the product with a cold engine
1. Run the basic product warm and then shut down the
product.
2. Mount the attachment as per the assembly
instructions.
3. When adjusting the carburetor, make sure that the
brush drums are held against the ground and that no
one else is in the vicinity.
4. Make sure the brush drums are idling.command.
5. Make sure that the handle and safety features are in
good working order. Never use a product that lacks a
part or has been modified outside its specifications.
To use the attachment
The sweeper works best when the rubber lamellas can
glide or 'stroke' the working surface. New or replaced
brush drums tend to fasten or drag on hard surfaces and
shall therefore be 'run in' thoroughly before use. This
can be done easily by operating the product at full
throttle for 3-5 minutes in loose gravel or similar grinding
material. After being run in, the sweeper will be able to
move large amounts of material from snow or puddles to
heavier objects such as gravel or wood chips. In time,
you will learn how the sweeper works but you must
observe safety precautions from the very beginning.
1. Run the sweeper at full (or nearly full) throttle with
the rubber lamellas resting on the surface.
Note: It is both tiresome and unnecessary to lift up or
hold the rubber lamellas above the surface while
working.
2. When clearing narrow surfaces such as paths, the
product can be used so that it throws materials
straight in front of you. If you want to work on wider
surfaces, you may need to work at an angle so that
strands form on one side. Strands comprising light
materials can be collected into one row or pile for
later removal while hard or more bulky materials may
need collecting in several strands.
3. In order to get into corners, remove the splash guard
and loosen the accessory coupling and rotate the
accessory half a turn.
WARNING: Rubbish will then be thrown
back towards the user. Use a lower
speed when reversing the product and
remember that it is easy to trip over
materials that are thrown out.
4. Keep a small working angle to the surface. Too large
a working angle means the sweeper tends to move
towards you and you risk losing control of the
product.
413 - 003 - 23.01.2020 7