RedMax RMS-EX600, Руководство оператора

Страница: 6 / 28

leads from the spark plug before you start to
work on it.
• Check the entire product before starting. Replace
damaged parts.
• Check that there are no fuel leaks and that all guards
and covers are complete and fastened securely.
Check all nuts and screws.
• Check that the brush drums are not damaged and
show no signs of cracking or other damage.
Assembly
To assemble the attachment
E
E
F
B
A
C
D
1. Press one of the drum axles (A) onto one of the two
outgoing drive shafts from the gear housing (F).
Rotate the drum axle if necessary so that the pin
hole comes over the corresponding hole in the drive
shaft.
2. Fasten the roller shaft with locking pin (B).
3. Thread one of the brush drums (C) onto the fitted
axle. The end with the extended rubber lamellas is
assembled closest to the gear housing. Press in the
brush drum.
4. Fasten the roller on the shaft with a cotter pin (D).
Press in the end slightly when assembling.
5. Repeat these steps to assemble the axle and roller
on the opposite side. The drums are identical but
must be assembled with the extended rubber
lamellas towards the gear housing.
6. Mount the splash guard with the snap-on fasteners
(E).
Note: For assembling accessories on basic product,
refer to manual for basic product.
6 413 - 003 - 23.01.2020