RedMax GZ5000, Руководство оператора

Страница: 24 / 120

To do a check of the vibration damping
system
1. Make sure that there are no cracks or deformation
on the vibration damping units.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
Refer to
Product overview on page 2
for information
about where the vibration damping system is on your
product.
To do a check of the start/stop switch
1. Start the engine.
2. Press the start/stop switch down to the STOP
position. The engine must stop.
To do a check of the muffler
WARNING: Do not use a product that has a
defective muffler or a muffler that is in bad
condition.
WARNING: Do not use a product if the spark
arrestor mesh on the muffler is missing or
defective.
1. Examine the muffler for damages and defects.
2. Make sure that the muffler is correctly attached to
the product.
3. If your product has a special spark arrestor mesh,
clean the spark arrestor mesh weekly.
4. Replace a damaged spark arrestor mesh.
CAUTION: If the spark arrestor mesh is
blocked the product becomes too hot and
this causes damage to the cylinder and
piston.
To adjust the idle speed screw (T)
The basic carburetor adjustments are done at the
factory. You can adjust the idle speed but for more
adjustments, refer to your servicing dealer.
To give the components of the engine sufficient
lubrication during run-in, adjust the idle speed. Adjust
the idle speed to the recommended idle speed. Refer to
Technical data on page 32
.
CAUTION: If the saw chain rotates at idle
speed, turn the idle speed screw
counterclockwise until the saw chain stops.
1. Start the product.
2. Turn the idle speed screw clockwise until the saw
chain starts to rotate.
3. Turn the idle speed screw counterclockwise until the
saw chain stops.
Note: The idle speed is correctly adjusted when the
engine runs correctly in all positions. The idle speed
must also be safely below the speed at which the saw
chain starts to rotate.
WARNING: If the saw chain does not stop
when you turn the idle speed screw, speak
to your servicing dealer. Do not use the
product until it is correctly adjusted.
24 1519 - 002 - 08.07.2020