Redlake MASD MegaPlus 4.2i, Руководство пользователя

Страница: 23 / 40

Mega Plus
®
Model 4.2i
3.10 Strobe Polarity
The STROBE OUTPUT on the rear panel of the camera provides a trigger signal for the user’s
stroboscopic light source. The polarity of the strobe signal is set by this command. Use the
leading edge of the strobe signal as the trigger point, because the trailing edge may vary. The
Strobe output is capable of driving a 50-ohm load.
TYPE IN: RESPONSE EXPLANATION
STP x CR-LF Sets the polarity of the strobe trigger pulse to positive
(STP P) or to negative (STP N).
STP?
STP P
STP N
Queries the strobe trigger output polarity.
Means the strobe output is a high going pulse.
Means the strobe output is a low going pulse.
Sample commands with arguments:
STP P Makes the strobe output a high going pulse.
STP N Makes the strobe output a low going pulse.
NOTE : The STROBE OUTPUT must be set to positive, STP P, if you are using a strobe
designed for use with the Mega Plus 4.2i camera.
3.11 Defect Correction
Occasionally, sensors are not perfect and have some areas that react differently to light. These
problem pixels are usually seen as a column that is different in intensity than the immediately
adjacent area. It is possible to characterize a sensor identifying the defective columns and then
program their locations into the camera at the factory. When defect correction is turned on, the
camera replaces the defective areas with information derived from nearby pixels making the
defects less noticeable.
TYPE IN: RESPONSE EXPLANATION
DEF xx CR-LF Enables (DEF ON) or Disables (DEF OF) Defect
Correction.
DEF?
DEF ON
DEF OF Queries the state of Defect Correction.
Means the Defect Correction is enabled.
Means the Defect Correction is disabled.
Sample commands with arguments:
DEF ON Turns on Defect Correction.
DEF OF Turns off Defect Correction.
3.12 Reset
TYPE IN: RESPONSE EXPLANATION
RST CR-LF Resets the camera to the settings as last saved.
Removing and then restoring power also performs a
reset.
91000058-003 Revision A 3-7 USER’S MANUAL