6
/
9
Manual control
This interface is used to control the current lighting and automatically enter the host state (does not
receive DMX signals emitted DMX signal to the slave from the mainline).
Manual menu will be Standard 16CH and Expand 20CH, the corresponding display 16 channels or 20
channels.
Before painting the
vertical 8
To
sleep
before
painting 8
Random
self-
propelled
Sound Control
DMX
Address
1~512
Press the "OK" button to enter the edit mode. At this point is
to select one hundred, press "up" "down" key to change the
address code. Press the "OK" button to select ten editing. Press
the "OK" button to select the bit editing. Press again to exit
edit mode
Channel
Mode
Standard 16CH
Standard 16 Channel Mode
，
17~20CH Invalid channel
Expand 20CH
Expand 20CH mode
，
17~20CHChannel Control Speed
（
See
channel table
）
X Reversion
off
on
Y Reversion
off
on
XY Exchange off
on
XY axis exchange channels (including trim)
XY Encoder on
Use encoder ( optocoupler ) judge out of step and
automatically correct position
off
Do not use the encoder (optocoupler) to correct position
Not
DMX
Signal
Maintain
Original state continues to run
Cleared
Motor back position, stop running
Screen Saver on
The idle 30 seconds after turning off the backlight
off
Backlight always on
Boot
light
bulb
off
Directly after power-on reset, not bright bulbs (need to use the
menu or the console to manually bulbs on)
on
Automatically after power-on bulbs on and to wait until the
lamp is lit successfully reset
Color wheel
linear
change
on
Color wheel linear change
off
Nonlinear changes color wheel, half color change
Restore
Default
Settings
Press the "OK" button to see a confirmation dialog box, press
the "OK" key to restore the default settings
