6
Installation Kit
Kit includes:
Warning:
Removal of the wire and seal
(16)
from locking screws will compromise
valve calibration and void the warranty! If service to the valve assembly effecting
calibration is required, it must be returned to manufacturer for service.
Field Provided Items
Items to be supplied by installer:
(see Figure 2 on page 8)
Pipe and flexible metal connection
(33)
Pipe Fittings
Drip leg
(31)
with Drain Port
¼” line
(37)
to connect Valve Body water drain hole
(24)
to Drip
Leg
(31)
A three inch (3”) Female NPT Pipe Union
(12)
(see Figure 2 on page 8)
Supplemental support materials (when applicable)
Typical Installation
NOTE:
See Figures
3 on Page 9
and 6 on
Page 10 for
location of
parts on
assembled
unit.
One (1) Pre-assembled NRS-3
RuptureSeal
™ which includes:
One non-fragmenting metal rupture disk 15 (PSI)
One flange gasket
Four (4) flange bolts with nuts
One (1) Tell-Tale pressure gauge 30” Hg - 0-30 psig
One (1) Double Check Pressure Equalizing valve with Filter/Vent
One (1) Installation Operation & Maintenance Manual
Chiller