7
9.
Block the wheels from moving. Disconnect the cable.
10.
Connect the cable at the pallet side of the Turf Tidy and raise the machine.
•
Be sure the unit is well secured, so it doesn’t move when lifting
•
The cable should be well secured to the chassis of the machine and lifting device.
11.
Raise the Turf Tidy and remove the pallet by disassembling the fixing points 8.
12.
Put the jack stand 16 on the Turf Tidy.
13.
Lower the machine till it stands on the jack.
14.
Next the machine can be prepared for the tractor, see chapter 2.1.
PS. If you are not sure how to assemble the parts, please study the spare part pages at
the end of this manual for a full understanding.
3.0 PREPARING THE TURF TIDY.
3.1 THE PULLED VERSION.
Both models are standard delivered as pulled versions.
Remove all straps that hold the machine together.
Start assembling the several items:
-
Top cover and door of hopper. They are reversed (4 in Fig.1.) and bolted (5) on the
hopper. Remove them completely. Mount the smallest front one first. Add the pivots.
Mount the door to the pivots only. Align the cover and door before finally tightening
all bolts and nuts. Check whether the door pivots well.
-
Add the PTO cover to the gearbox.
-
The rear roller may need assembly
-
The front roller with the two jacks has to be mounted to the head.
The Turf Tidy draw bar 1 can be fitted in two position, see Fig.2 and 3. This allows the
machine to cope with an upper and bottom tractor hook up point.
The draw bar plate 8 can be bolted on in four positions. Since it is bent, it can be set at two
different positions ( 8 and 9), above and under the main draw bar box section. Choose the
position at which the draw bar plate aligns the best with the tractor hook up. Tighten all bolts
carefully.
