Redexim RINK DS 3800, Инструкция по эксплуатации и каталог запасных частей

Страница: 17 / 18

DS3800 - 17 -
Troubleshooting
Problem Cause Solution
Gate does not
open Throttle valve set too weak Adjust throttle valve (9) until gate
opens (see page 13)
Spreading width
is too narrow Spreading discs turn too slowly Increase spreading speed using a
controller (2) (see page 9 and 10)
Spreading
thickness to thin Too little material is transported
Spreader speed set too high
Conveyor belt speed too slow Increase gate opening
(See page 9 and 10)
Reduce spreader speed using a
controller (2)
(See page 9 and 10)
Increase conveyor belt speed using
the controller (1)
(See page 9 and 10)
Spreading
thickness too
thick Too much material is transported
Spreader speed set too
slow
Conveyor belt speed too high Reduce the gate opening
(See page 9 and 10)
Increase spreading speed using a
controller (2) (see page 9 and 10)
Reduce conveyor belt speed using
the controller (1)
(See page 9 and 10)
Uneven
spreading pattern Spreading disks are set incorrectly Set the spreading discs (8) correctly
(See page 11)
Uneven flow rate Conveyor belt speed too slow Increase conveyor belt speed using
the controller (1)
(See page 9 and 10)
Conveyor belt
does not start Conveyor belt slips
Driving pulley at the back and
conveyor belt does not turn Retensioning the conveyor belt
(See page 14)
Increase pressure in the relief valve
(10) by turning a quarter turn
clockwise
(See page 13).
Hydraulics are
not working Check if hoses are connected
properly If necessary, replace pressure (4)
and return lines (3) (see page 9)
Fig.11: Troubleshooting