HoneyBadger Installation Manual
HoneyBadger Install Version 2
Page 11 of 32
Issue Date 18/07/2022
Installation – 8 steps for installation and customer handover
The SunRise system is designed to be easy to install. It includes prewired connection points and
comprehensive labelling and parts kit to simplify the installation.
Technical support is available directly from RedEarth during installation if required.
8 steps to complete your HoneyBadger installation:
1.
Transporting getting the HoneyBadger to site
2.
Positioning – the HoneyBadger in its final location on site
3.
Solar Install
4.
Electrical connections at the HoneyBadger
a.
Solar
b.
Battery
c.
Load
d.
Generator
e.
Generator Auto-Start
f.
Remote monitoring
5.
Turn On and Shutdown procedure
6.
Commissioning the HoneyBadger
7.
Activating remote Monitoring – contact RedEarth to confirm remote operation
8.
Customer Handover – including helping with access to RedEarth EMU app
Step 1. Transporting
The HoneyBadger system is supplied on a pallet as shown at right.
It is fully set-up, factory-tested and ready to run. The system weighs
around 392kg with 4x lithium batteries and requires lifting
equipment to handle it. The system can only be lifted from the
base.
The base of the system has spaces for either a forklift or a standard
trolley jack to be used.
If the HoneyBadger is too heavy to manage the lithium batteries
can be removed and replaced once the system is in position. Each
battery module weighs 42kg and up to eight (8) can be installed in
the system.
Cable entry options are available on both sides of the system. They
are designed for 25mm and 32mm conduit, and glands are
provided in the spares which clamp onto 25mm flexible conduit.
Air inlet vents are included in the base and sides of the system. Do
not block them.
The Face Plate comes strapped to the side of the unit to avoid transport damage