RedBack Lasers EGL624G, Инструкция по эксплуатации

Страница: 8 / 16

8
EGL624G
TM
OPERATING INSTRUCTIONS cont.
Setting Slope/Grades
(refer to diagram page 4)
The EGL624G
TM
can be used to set grades. In Slope (Grade) Mode you can
set a Grade in either the X or the Y Axis of up to 8% see the markings on
top of laser for axis alignment. With the EGL624G both “TILT” and “V-W-S”
modes can be used. The EGL624G is dual grade capable so a grade can be
set on the X and Y axis simultaneously, however, only when in manual mode
page 10.
• Turn the laser on, allow to level and begin rotating.
• On either the key pad of the laser or on the remote control a short press
of the Slope (Grade)/Manual Mode button will activate slope mode
indicated by LED and the X LED will also illuminate. Note a long press
will enter Manual mode see page 10.
• Select the axis you wish to grade by again pressing this same button
and the selected X or Y axis LED will light. A long press when already
in slope mode will exit back to normal levelling.
• Move the laser plane on the selected axis up or down using the Slope
Grade Direction buttons . For dual grade use manual mode
see page 10.
• To reset and re-level press and hold the Slope Grade button .
www.redbacklasers.com.au