Redarc DPS1225, Руководство пользователя

Страница: 13 / 16

13
6 TROUBLESHOOTING
NO
NO
NO NO
NO
NO
NO
Review system:
Reduce loads or increase
size of DPS as required.
The DPS is not operating
correctly. Have a qualified Auto
Electrician check the wiring,
fuses, batteries and charging
system or contact REDARC
Electronics for more information.
The DPS is operating
correctly. If a low output
voltage occurs - check
BROWN wire is making a
good connection to the
load(s). If the problem is
still evident, have a
qualified Auto Electrician
inspect the system.
Check the connection to
the DPS, and the
orientation of the LED as
per the install diagrams.
If the problem is still
evident contact a
qualified Auto Electrician,
or REDARC Electronics.
Check that the alternator
is charging properly. If the
problem is still evident
contact a qualified Auto
Electrician or REDARC
Electronics.
Check the RED wire.
Is it installed with
appropriate gauge wire
and connected to the
source you require?
Is the ‘Output Status’
light ON or flashing?
If an External LED is
fitted, is it working as
described on page 6 of
this manual?
Is the BLUE wire
connected?
(DPS needs =12/24V
applied for DPS to
operate)
Are all load negative wires,
and BLACK DPS wire
connected to a common
ground point? (chassis)
Is the input voltage
(RED wire) between
9–32 VDC?
Is the load within the
DPS’s specified
range?
Shutdown the vehicle
and rectify the problem.
Start and run engine
for 30 seconds - leave
engine running whilst
troubleshooting.
YES
YES
YES
YES
YES
YES
YES