10
Fig. 5
Fig. 6
5. Disassemble the M5 x 10 mm Bolt from
the Post (D). Put the assembled tabletop
(G)+(H) to Post (D). Don’t reassemble
the M5 x 10 mm Bolt to the Post (D) until
Step 6 is complete.
Notes:
When the Tabletop (G) is well attached,
follow the steps below to adjust the
height:
a. Adjust the grip until it is vertical to the
post.
b. Adjust the height of the tabletop
to
desired position
.
c. Fix the position of the tabletop by
turning the grip clockwise.
d. Turn until the grip is fixed.
e. Clasp the chain to further fix the grip
6. Feed the valve and gas line and
connect the Burner Assembly (C) to
Post (D).
6.1: Feed the valve and gas line into
and through the Post (D).
6.2: Screw Burner Assembly (C) onto
Post (D) until the hole on the
Upper Post Assembly (Q) is
aligned with the holes on top of
post (D). Fix by using one M5 ×10
mm Bolt (DD.). Ensure they are
fully tightened.
6.3: Reassemble the M5 x 10 mm Bolt
to Post (D) in order to limit the
height of the tabletop (G). Refer to
Fig. 5 & Fig. 6
Notes:
a. Open the igniter cap by unscrewing the cap
counterclockwise
b. Take out the battery included in the
pack of Instruction manual.
c. Insert the battery to the igniter.
M5 X 10
mm Bolt
Battery
Ignitor
C
Q
DD
D
DD
X 3
M5X10 mm Bolt
＋
－
M5 X 10
mm Bolt
D
G
H
