CONNECTING THE
MICRO SYNC TO YOUR
SYSTEM
When you have chosen the best
mounting option for your system setup,
connect the MICRO SYNC as follows:
1. Using the input cable
,
connect the 3.5mm plug end to the
socket marked ‘INPUT’ on
the
panel.
2. Connect the RCA phono plugs of the
cable to a suitable line level output on
your mixing desk. (Record, Booth etc.)
3.
Connect the MIDI OUT socket on the
front panel of the MICRO SYNC to the
MIDI IN socket of your sequencer, using
a suitable MIDI cable.
supplied
MICRO SYNC
rear
Connect the output plug of the AC
power adaptor to the MICRO SYNC’s
power in socket on the rear panel.
4.
You can choose one of three mounting options
included with the MICRO SYNC.
1.
- Stick one in each corner on
the underside panel for free mounting.
2.
- Stick one
either side of the serial number label on the
underside panel. Locate a flat, clean surface
on your equipment/rig, peel-off film and press
firmly into place for a permanent mounting.
3.
- The MICRO SYNC
can be conveniently located on either side of a
mixing desk for a semi-permanent mounting.
Rubber feet
Double sided adhesive pads
Brackets, for use with 19” rack mount
holes on mixing desks
MOUNTING THE MICRO SYNC
MOUNTING/CONNECTIONS
INPUT CABLE
(SUPPLIED)
TO AC
ADAPTOR
19” RACK
Hole pitch
range =
Min 90mm
Max 240mm
Rotate the chrome
brackets to line-up
with the 19” rack
mounting holes on
your mixing desk.
M3 SCREW
(LENGTH = 6mm MAX)
BRACKET
M6 SCREW
M6 NUT
DJ MIXING DESK PANEL
19” RACK MOUNT HOLE
MIXING DESK
MIDI OUT
R
ED
MICRO SYNC
Beat Xtractor
MIDI CLOCK
BEAT 1
TAP
/
(RESET
/STOP)
OK
PULL
PUSH
SYNC
R
L
MIDI IN
SUITABLE
MIDI CABLE
TO SUB-MIXER:
DO NOT
CONNECT MIDI AUDIO
SIGNAL BACK INTO MAIN
MIXER AS A FEED-BACK
LOOP WILL OCCUR.
MIDI SEQUENCER / TONE MODULE
AUDIO OUT
RECORD/BOOTH
OR
MASTER OUTPUT
303/505
NUDGE
PULL
BPM
-/DOWN
BPM
+/UP
PUSH
3
PA
G
E
