UTILITY MODE CHANGES
The utility section has the following changes:
Protect ON/OFF - see page 30 in main manual
Save PROGRAM - see page 31 in main manual
Save SEQUENCE - Saves the currently selected sequence. Display shows ‘SEOU’
Save ALL PROGRAMS - see page 32 in main manual.
Save ALL SEQUENCES - All 96 sequences in programs 1 to 24 (Banks 1,2 &3) will be saved.
UTILITY 1:
UTILITY 2:
UTILITY 3:
UTILITY 4:
UTILITY 5:
Note: all 64 programs are saved as one dump.
22
OPERATION
DarkStar Vocoda
USING THE VOCODA WITH NON-MIDI INSTRUMENTS
TROUBLESHOOTING
You can use the VOCODA filters for processing non-MIDI instruments such as guitars, electric bass etc. The facility
for setting the trigger mode to [AUDIO] lets you route such a signal through the filter whilst applying real-time
modulation to the sound. These effects can transform a guitar/bass sound.
Follow these instructions to setup VOCODA in this way:
1. Connect your guitar/bass signal to the [EXTERNAL] input 1 (and 2 if stereo required). Post (after) effects units or
send/return patch from amplifier will work best.
2. Select [FILTER] type in the first [VOCODER] menu
3. Select [AUDIO] trigger mode in the first [PORTA/TRIGGER] menu
4. Select [VOCODER] menus 5 and 6 and adjust the modulation depth / source (try ENV2 source with
approxi5 modulation depth as a start). Experiment with these settings.
5. Select [ENVELOPE] 2 (indicator in [ENVELOPES] button = ON) and set the controls roughly as follows:
This will apply a sharp ’wow’ effect each time a note or chord is struck. Try adjusting the envelope controls to
change the shape of the sound.
6. Adjust the [VOCODER CONTROL] joystick to change the basic filter frequency. The position of the joystick has a
direct relation to the mod depth i.e. whether it is positive or negative. With positive mod applied, use the joystick
towards the upper left-hand side position. With negative mod applied, use the joystick towards the upper right-hand
side position.
Unit locks up/operation erratic
Have you changed EPROM’s without re-initialising?
Sequence will not run
Vocoder [MIDI CLOCK] set to ON
MENU indicator appears to be stuck ON
Vocoder [MIDI CLOCK] set to ON (event paused waiting for clock)
Sequence record mode inactive
Vocoder switched OFF (main VOCODER button indicator off)
Problem
Check
DECAY
ATTACK
RELEASE
SUSTAIN
Max
Max
Max
Max
Min
Min
(VELOCITY)
Min
Min