Red Sea REFEER, Руководство по эксплуатации, Страница: 59 / 105

Place the mounting bracket in the desired
position on the back wall of the aquarium.
Insert the mounting column to the bracket
and fix in position with 2 screws provided.
Hand-tighten the screws only! Do not attach
the LED modules at this time. Do not insert
the cable plugs into the hole in the arm.
Make sure that the mounting arm is in the
horizontal position.
1. Remove the fan cover. Slide the connector plate into the
module so that the threaded bushings in the plate are aligned
with the holes in the aluminum.
2. Using the M3 screws provided, lightly attach the swivel
connector as shown in the diagram. Replace the fan cover and
ensure that the swivel connector is parallel to the top of the
aluminum before tightening the screws.
3. Put the swivel connector pins and fixing screw within easy reach
of the aquarium. Locate the LED Module in front of the mounting
arm and push swivel connector in position. Insert the connector
pins to both sides and push until firmly in position. Screw the
fixing screw into the top of the connector. Adjust the position of
the LED module until it is parallel with the top of the aquarium
and tighten the fixing screw. The swivel connector allows
rotational adjustment for personal preference of approximately
5 degrees.
4. Bring the cable to the rear of the mount and thread the cable
through the hole in the arm so that there is sufficient cable to
plug the DC jack into the connector on the LED module. Flatten
the cable against the underside of the mounting arm and
insert the bottom cable plug. Insert the cable plug into the top
of the arm so that the cable is facing backwards.
WARNING : The LED module is not waterproof. Do not get the unit wet and do not submerge any part of it or
the power cord in the aquarium water.
WARNING : LED lights produce extremely intense light output that may damage or injure your eyes.
Do not look directly into the LED’s any time the fixture is illuminated.
1
2
2
1
2
1
2