13
Web Editor
The web editor can be used to configure your pedal, access hidden parameters, and fine-tune presets.
It is intended for "offline" configuration and editing. For live performance editing, we recommend using
dedicated MIDI hardware or software and MIDI control change messages.
Connect your pedal to a computer using a USB cable and go to the web editor URL using Chrome:
https://www.redpandalab.com/content/apps/bitmap-editor/index.html
Note the
https in the URL. http will not allow the browser to acess your MIDI devices.
The editor uses Web MIDI, which is not supported by all browsers. We officially support Chrome.
Pedal Status
The web editor indicates whether the pedal is connected. If the status is "not found", ensure that the
pedal is turned on and connected to your computer. Click the refresh button to refresh the status.
Edit
The Edit tab shows all of the pedal's realtime parameters. The on-screen controls are updated to match
the current state of the pedal, but hidden parameters are not updated. Press the
Refresh button to up-
date all of the parameters. The web editor's controls allow higher resolution changes than MIDI continu-
ous controller messages.
Ctrl Port
The Ctrl Port tab allows you to configure the pedal's
CTRL port for an expression pedal or remote switch.
The control port mode (expression or remote) is stored globally, but expression pedal assignment and
remote switch configuration are stored in each preset.
The expression pedal can be assigned to up to 6 parameters, with a minimum/maximum range for each.
Preset
The Preset tab allows you to send MIDI program change messages and save presets to the pedal's on-
board memory. Preset 1 is also available via the pedal's
PRESET footswitch.
Config
The Config tab allows you to configure the pedal for your setup.
If the pedal detects an error condition, a diagnostic code will be displayed on this tab.
