© 2001, RED LION CONTROLS, ALL RIGHTS RESERVED.
Information in this document is subject to change without notice and does not represent a commitment by Red Lion
Controls. Software, which includes any database supplied therewith, described in this document may be furnished subject
to a license agreement or a nondisclosure agreement. It is against the Law to copy the software except as specifically
allowed in the license or nondisclosure agreement. No part of this document may be reproduced in any form or by any
means, electronic or mechanical, including photocopying and recording, for any purpose, without the express written
permission of Red Lion Controls.
PowerPoint and Windows are registered trademarks of Microsoft Corporation. Other product and company names
mentioned herein may be the trademarks of their respective owners.
Disclaimer
Red Lion Controls, hereinafter referred to as RLC, will under no circumstances be responsible for direct, indirect,
special, incidental or consequential damages, death or personal injury arising from the use or misuse of all or part of this
documentation or the products and software described herein. Notwithstanding the above, RLC does not exclude any
liability for death or personal injury caused by its negligence.
RLC does not warrant any of its software products to be free from error or to be fit for any particular purpose. Neither
is the software guaranteed to provide operation without interruption. The customer's sole remedy in case of failure is the
refund of the purchase price of the software.
The customer, in applying the products and software described herein, accepts that the products are wholly or partly
programmable electronic systems that are inherently complex and which cannot thus be guaranteed to be free of errors. In
doing so, the customer accepts the responsibility to ensure that the products are correctly programmed, configured,
installed, commissioned, operated and maintained by competent and suitably trained staff and according to any instructions
or safety instructions provided and as dictated by good engineering practices.
This documentation, and the software and products described herein, is subject to continuous development and
improvement. All information is given in good faith, but RLC shall not be liable for any omissions or errors herein or
within the software herein described.
PROGRAMMING PORT PIN OUT
The Operator Interface’s programming port is sometimes used to connect
other RS-232 devices, such as printers. The following illustration and table
gives the pin-out of this port to enable such connections to be made.
The above table denotes the pin names of the programming port. When
connecting, the pin name at the programming port is connected to the opposite
of that pin name at the destination device.
TROUBLESHOOTING
For further technical assistance, contact technical support at the appropriate
company numbers listed.
Rear View of Unit
Red Lion Controls
20 Willow Springs Circle
York PA 17402
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
Red Lion Controls BV
Databankweg 6C
NL - 3821 AL Amersfoort
Tel +31 (33) 472 32 25
Fax +31 (33) 489 37 93
Red Lion Controls France
56 Boulevard du Courcerin, Batiment 21,
ZI Pariest F-77183 Croissy Beaubourg
Tel +33 (64) 80 12 12
Fax +33 (64) 80 12 13
