red lion GEMINI 1000, Инструкция по эксплуатации

Страница: 32 / 60

The Gemini is intended to be mounted into an enclosed panel with a gasket
to provide a water-tight seal. The unit meets NEMA 4/IP65 requirements for
indoor use when properly installed. Two mounting clips and screws are
provided for easy installation. Consideration should be given to the thickness
of the panel. Too thin of a panel may distort and not provide a water-tight seal.
(Recommended minimum panel thickness is 1/8".)
After the panel cut-out has been completed and deburred, remove the
backing from the adhesive side of the gasket, and carefully stick the gasket to
the panel. DO NOT APPLY THE ADHESIVE SIDE OF THE GASKET TO
THE COUNTER BEZEL. Insert the unit into the panel. As depicted in the
drawing, install the screws into the narrow end of the mounting clips. Thread
the screws into the clips until the
pointed end just protrudes through
the other side. Install each of the two
mounting clips by inserting the wide
lip of the clips into the wide end of the
holes located on either side of the
case. Tighten the screws evenly to
apply uniform compression, thus
providing a water-tight seal.
CAUTION: Only minimum
pressure is required to seal panel. Do
NOT overtighten mounting screws.
–30–
APPENDIX “A” - INSTALLATION & INPUT CONFIGURATION SWITCH SET-UP
Before installing the Gemini into the panel, the user should first become
familiar with the unit. It may also be desirable to program the unit for the
application at hand (Refer to the “Programming and Applications” sections) .
Once the unit is programmed, the settings will be saved in memory. The Program
Disable “PGM. DIS.” terminal should be connected to “COMM.” to prevent
accidental or unauthorized programming changes.
Installation Environment
The unit should be installed in a location that does not exceed the maximum
operating temperature and provides good air circulation. Placing the unit near
devices that generate excessive heat should be avoided.
The bezel should be cleaned only with a soft cloth and neutral soap product. Do
NOT use solvents. Continuous exposure to direct sunlight may accelerate the
aging process of the bezel.
Do not use tools of any kind (screwdrivers, pens, pencils, etc.) to operate the
keypad of the unit.
PANEL MOUNTING (Note, See Appendix “B” for Dimensions)