red lighting Classe BS 2, Руководство пользователя

Страница: 23 / 33

Classe BS2 v1.0 22
3
．
Press< ENTER>, the display will show
“
Mic Sensitivity
”
.
4
．
The display show
“
70%
”
,Press <Up/Down>, the display will show
“
0~99%
”
.
5
．
Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
Hibernation ——Standby mode
The lamp and step motors will be power off if the fixture stay without DMX signal for 15
mins (Factory default).And the fixture will be reset before working once it receive DMX
signal again.
1
．
Tap <MODE/ESC>button
，
access the main menu
，
Tap the <Up/Down>button until
“
Personality
”
is displayed. Press ENTER, the display will show
“
Personality
”
. Tap the
<Up/Down>button until the display will show
“
Status setting
”
. Press ENTER, the
display will show
“
Status setting
”
.
2
．
Press <Up/Down>, the display will show
“
Hibernation
”
.
3
．
Press< ENTER>, the display will show
“
Hibernation
”
.
4
．
The display show
“
15M
”
,Press <Up/Down>, the display will show
“
01M
”，
“
02M
”
….
“
99M
”
or
“
OFF
”
.
5
．
Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.4.2 Service setting
Password—— The Password for this function is “50”.
RDM PID—— With this function you can call up various submenus via RDM.
This device is RDM ready. RDM stands for "remote device management" and makes remote
control of devices connected to the DMX-bus. ANSI E1.20-2006 by ESTA specifies the RDM
standard as an extension of the DMX512 protocol.
Manual settings like adjusting the DMX starting address are no longer needed. This is
especially useful when the device is installed in a remote area.
RDM ready and conventional DMX devices can be operated in one DMX line. The RDM
protocol sends own packages in the DMX512 data feed and does not influence conventional
devices.
If DMX splitters are used and RDM control is to be used, these splitters must support RDM.
The number and type of RDM parameters depend on the RDM controller being used.
9.4. 3 Fans Control
With this function, you can set the speed of the running fans. The selection have auto, high and low.
9.4.4 Display settings
Shut off time
With this function you can shut off the color LCD display after 2 to 59 minutes. Turn the
encoder in order to select the desired shut off time. The default is 5 minute.