INS
TALLA
TION INS
TRUCTIONS
Red Arrow Trading
Elsworth House, Herries Road South
Sheffield, S6 1QS
T: 0800 195 0006 F: 0870 195 0006
www.redarrowtrading.com
SMD LED FLOODLIGHTS WITH
PHOTOCELL
FOR MODEL: FLSMD50BPC-1, FLSMD100BPC-1, FLSMD150BPC-1 &
FLSMD200BPC-1
SAFETY WARNING
• The installation should be carried out by a qualified electrician in compliance with the current edition
of the IEE Wiring Regulations.
• Prior to installation carry out the necessary risk assessment considering the people who could be at
risk, the level of risk and the precautions required to control the risk.
• Ensure that the circuit supply is isolated either by the circuit supply fuse being removed or the
applicable circuit breaker being turned off before installation or any maintenance.
• Check the total load on the circuit including the luminaire does not exceed the rating of the circuit
cable, fuse or circuit breaker.
• If the fitting incorporates control gear, ensure careful sizing to avoid instances of nuisance tripping of
the protective device used in the installation.
•
Follow the provided installation instructions, using the fixings supplied or recommended.
INSTALLATION DIAGRAMS
1. Ensure there is adequate free air circulation of at least 100mm
around the luminaire. All luminaires run hot. It is the installer’s
responsibility to consider any fire risks and take appropriate
precautions.
2. Before commencing installation ensure electricity is switched
off at the mains.
3. The nearest illuminated surface must be at least 0.5m from
the front of the fitting.
4. Do not install in areas where the lens will become dirty.
5. Do not allow an artificial light source to activate the photocell,
as the light may flash ON and OFF.
6. Do not use if the glass is broken, contact your supplier for a
replacement.
7. Drill two holes according to the holes on the bracket, on a wall
or similar hard surface.
8. Fix the bracket to the wall or similar hard surface with suitable
fixings (not included).
9. Connect the cable correctly to the mains supply observing all
of the colour-coding below. Ensure all electrical
connections are tight with no loose strands.
L = Brown
= Green/ Yellow
N = Blue
