Recsea WHR-WG50 P, Руководство пользователя

Страница: 7 / 10

1. Using the O-ring Removal Pick, remove O-ring.
2. Clean sand, salt, other contaminants and old grease from O-ring.
3. Clean O-ring Groove and O-ring Contact Surface using a clean cotton swab.
4. Visually and physically check O-ring by running it through finger tips, feeling for cuts,
cracks or any other defects that may cause leakage. Such defects will cause water
leakage, so be sure to replace the O-ring. Be careful not to stretch or pull the O-ring too
much.
5. Squeeze a rice grain sized bead of silicone grease on your thumb and forefinger. Taking
care not to pull or stretch the O-ring too much, uniformly spread grease on O-ring. Too
little grease may cause the O-ring to twist in the groove, possibly causing water leakage.
6. Place O-ring in the Back Cover O-ring Groove, making sure that it is uniform, not twisted
or bulging out, possibly causing water leakage. When closing back cover, visually check
O-ring and O-ring Contact Surface to make sure no hair, lint or other contaminants are
attached.
IMPORTANT NOTES:
※
When housing is not used for long periods, remove O-ring and place in separate plastic
bags to keep it free of dust and other contaminants and store in a place out of direct
sunlight. Please also be careful of prolonged exposure to direct sunlight during use. The
O-ring and housing may become deformed, causing water leakage.
※
After extended periods of non-use, install the O-ring and soak closed empty housing in
lukewarm for half a day. Manipulate all buttons several times. Using a soft, dry cloth wipe
away water.
CAUTION!
※
The O-ring is an essential part of waterproofing for this housing. Not properly greasing the
O-ring as directed may cause the O-ring to twist in the O-ring groove, possibly causing
water leakage.
※
Always perform the above O-ring, O-ring groove and O-ring contact surface maintenance
and greasing every time you open/close the housing.
※
Please pay close attention and make sure the O-ring is not twisted or bulging, free of any
contaminants (dirt, hair, etc.), and that foreign objects do not obstruct proper closing of the
housing Back Cover.
※
DO NOT clean the housing with volatile organic solvents or chemical cleaning agents such
as thinner, gasoline, and benzine, etc.
※
Housing Monitor is manufactured using hard coat acrylic. When cleaning use a clean soft
cloth taking care not to scratch it.
INSURANCE INFORMATION
※
Seatool/Recsea strongly recommends insuring your camera. For more information please
contact your dealer.
5.