ATTENTION!
※
The housing Mode Dial is designed to turn the camera's mode dial back and forth via
friction from the o-ring that comes in contact with the mode dial inside the housing. Should
the Control Wheel begin to slip, use soft dry cloth to wipe away any oil and other
contaminates that may cause the loss of friction.
※
Use External Strobe Connection Adapter as required for attaching fiber optic flash cable.
Be sure to attach Diffuser and shown above.
※
Please refer to camera manual for explanation of button functions.
※
When installing or removing camera pull Mode Dial up. When installing be sure to place
the Dial contact in the proper position.
NOTE:
During use make sure the housing Mode Dial is down.
OPENING AND CLOSING THE BACK COVER
※
Please do the following operations in a clean area with low humidity and dust.
Open & Close Dial Locks in two places, in the open position and in the closed position.
1. To open, while pressing the Open & Close Lock Button, turn the Open & Close Dial to the
right (clockwise). Due to pressurization, the back cover may be difficult to open, turn
strongly.
2. The back cover will open once the dial is turn completely to the right.
3. To close, seat back cover into place and press firmly (Note: Dial will turn to the left
(counterclockwise). While pressing the Open & Close Lock Button, turn the Open & Close
Dial completely to the left making sure the Open & Close Lock Button is engaged (Note: If
lock button is flush with dial base the lock is not engaged properly.)
※
NOTE:
Firmly press Lock Button while turning dial. Failing to do so may cause damage to
locking mechanisms.
CAUTION!
Before using, please be sure the test the housing (without camera) in bucket or
aquarium if available. After use in salt water, rinse thoroughly in a bucket of fresh water
without fail, pressing all buttons several times to flush out salt deposits and other
contaminants. Allowing saltwater and contaminants to dry on housing can damage functions
and O-Ring. Clean with fresh water only, using a soft, dry cloth to wipe away water.
HANDLING PRECAUTIONS
The Lens is manufactured using hard coat acrylic. When cleaning use a clean soft cloth
taking care not to scratch it.
3
