Recsea WHC-G7X, Руководство пользователя

Страница: 6 / 11

※
Please perform proper Housing O-RING MAINTENANCE prior to installation.
※
Please conduct the following operations in a clean area with low humidity and dust.
1. Make sure the housing Mode Dial is pulled (or pushed) outward away from housing, and
camera flash is closed. If these steps are not taken, the camera may not seat properly
into housing and may caused dials and lever not to function as intended.
2. Check camera settings, battery is charged and media storage capacity is sufficient.
Slowly and carefully install camera making sure camera does not to hit housing's internal
controls. If the camera is not inserted correctly, buttons, dials, and levers may not work
properly.
3. After performing O-ring Maintenance, carefully close back cover making sure nothing is
caught between the Secure-Latch and housing. Push Secure-Latch into the locked
position making sure the Lock Lever is in the locked position. Double check to make sure
the Secure-Latch is securely locked into place.
REMOVING CAMERA
CAUTION! After use in water, water will remain in gaps between housing, back cover and
Secure-Latch. Wipe any water off housing with a soft dry towel to prevent water from falling
on camera.
1. Pull Mode Dial upward away from Housing.
2. Press Lock Lever while pulling Secure-Latch away from housing main body . Open back
cover.
3. Tip Housing backwards, gently sliding camera out of housing.
HANDLING PRECAUTIONS
The Port Lens is manufactured using hard coat acrylic. When cleaning use a clean soft cloth
taking care not to scratch it.
INTERNAL AND EXTERNAL STROBE
※
For heavy strobes and lights please use optional Grip & Tray Assembly and compatible
connector.
※
While in the housing, the camera's on-board strobe can be deploy using the housing
Control Wheel Dial and proper camera function. The G7X camera on-board strobe does
NOT close when the camera is turned OFF. Be sure to manually close the strobe once
removed from housing.
※
Use the Strobe Mask-External Strobe Connection Mount to connect external strobe fiber
optic cable.
Connecting fiber optic cable for external strobe use:
CAUTION! Store Strobe Mask-External Strobe Connection Mount and Screw in a secure
place so as not to lose them.
1. Using the Strobe Mask-External Strobe Connection Mount Screw, attach the Strobe Mask
-External Strobe Connection Mount by screwing it into the Screw Hole provided.
2. Insert bear fiber-optic cable (INON) or plug (SEA&SEA) into sockets provided.
4.