Recsea WHC-G7X, Руководство пользователя

Страница: 5 / 11

※
Please refer to camera manual for explanation of camera controls.
ATTENTION!
※
The housing Mode Dial is designed to turn the camera's mode dial back and forth via
friction from the o-ring that comes in contact with the mode dial inside the housing. When
installing or removing camera pull Mode Dial up. When installing be sure to place the Dial
contact in the proper position. Should the internal Control Wheel begin to slip, use a soft
dry cloth to wipe away any oil and other contaminates that may cause the loss of friction.
※
Please refer to camera manual for explanation of Control Dial and Control Ring Dial.
※
Use Strobe Mask-External Strobe Connection Mount as required for attaching fiber optic
flash cables.
※
Attached Diffuser using the grooved provided on the Lens Port as shown above.
OPENING AND CLOSING THE BACK COVER
※
Please do the following operations in a clean area with low humidity and dust.
To OPEN, press Lock Lever while pulling Secure-Latch away from housing main body.
To CLOSE, press Secure-Latch into place making sure the latch on the underside is properly
placed in the Secure-Latch groove attached to the main housing body. Push into the locked
position. Double check to make sure it is firmly locked into place.
INSTALLING CAMERA
CAUTION! Before using, please be sure the test the housing (without camera) in bucket or
aquarium if available. After use in salt water, rinse thoroughly in a bucket of fresh water
without fail, pressing all buttons several times to flush out salt deposits and other
contaminants. Allowing saltwater and contaminants to dry on housing can damage functions
and O-Ring. Clean with fresh water only, using a soft, dry cloth to wipe away water.
3.