INSTALLING LENS PORT
※
Please perform proper Housing Port and Lens Port O-RING MAINTENANCE prior to
installation.
※
Please conduct the following operations in a clean area with low humidity and dust.
CAUTION!
Only use the Lens Ports intended for this housing. Failure to use the proper Lens
Port could result in image vignetting and distortion, as well as possible water leakage and/or
damage to the camera.
1. Prepare the Lens Port to be used.
2. Lightly grease-up Housing Port O-ring Contact Surfaces.
3. Place Lens Port over Housing Port with Lens Port Lock Tabs aligned with Lens Port Tab
Grooves making sure the Lens Port Lock Tab is at the bottom.
4. With Lens Port is resting evenly on the Housing Port push down onto Housing Port.
5. With Lens Port evenly pushed down onto Housing Port, rotate Lens Port
counterclockwise until the Lens Port Release Lever engages with an audible click.
REMOVING LENS PORT
CAUTION!
After use in water, before removing Lens Port wipe any water off housing and
Lens Port with a soft dry towel to prevent water from falling into the housing and onto
camera.
1. Unlock the Lens Port by pulling Lens Port Release Lever as shown above.
2. Rotate Lens Port clockwise until Lens Port Lock Tab is visible and position at the bottom
of the housing.
3. Carefully pull Lens Port from Housing Port.
HANDLING PRECAUTIONS
※
The Lens Port is made of Polyoxymethylene (POM). Excessive vibration or impact from
dropping or striking can damage the port . Such damage is NOT covered by warranty.
5.