To OPEN, press Lock Lever while pulling Secure-Latch away from housing main body.
To CLOSE, press Secure-Latch into place making sure the latch on the underside is properly
placed in the Secure-Latch Groove attached to the main housing body. Push into the locked
position. Double check to make sure it is firmly locked into place.
CAUTION!
Due to pressurization after submersion, water on and around the closure may be
sucked in at time of opening. be sure to wipe all excess water from housing before opening.
CAUTION!
Before using, please be sure to test the housing (without camera) in a bucket of
freshwater. After use in salt water, rinse thoroughly in a bucket of fresh water without fail,
pressing all buttons several times to flush out salt deposits and other contaminants. Allowing
saltwater and contaminants to dry on housing can damage functions and O-rings. Clean with
fresh water only, using a soft, dry cloth to wipe away water.
INSTALLING CAMERA
※
Please perform proper housing and port O-RING MAINTENANCE prior to installation.
※
Please conduct the following operations in a clean area with low humidity and dust.
※
Camera can be inserted with lens port attached.
1. Check camera settings, battery is charged and media storage capacity is sufficient.
2. Open camera flash.
NOTE: The camera flash cannot be deployed after housing is closed and the camera may
not seat properly causing housing dials, buttons, and levers not to function as intended.
3. Carefully install camera making sure camera does not to hit housing's internal controls. If
the camera is not inserted correctly buttons, dials, and levers may not function properly.
4. After performing O-RING MAINTENANCE, carefully close back cover making sure
nothing is caught between the Secure-Latch and housing. Push Secure-Latch into the
locked position making sure the Lock Lever is in the locked position. Double check to
make sure the Secure-Latch is securely locked into place.
REMOVING CAMERA
CAUTION!
After use in water, water will remain in gaps between housing, back cover and
Secure-Latch. Wipe any water off housing with a soft dry towel to prevent water from falling
on camera.
1. Press Lock Lever while pulling Secure-Latch away from housing main body. Open back
cover.
2. Carefully tip Housing backwards, gently sliding camera out of housing into hand.
4.