Recsea RDH-SA6000, Руководство пользователя, Страница: 5 / 12

2. Check camera settings, and that battery charge and media storage capacity are
sufficient.
3. Making sure the housing ON/OFF Power Switch is the in proper position, Slowly and
carefully install camera making sure camera does not hit housing's internal controls. If the
camera is not inserted correctly, buttons, dials, and levers may not work properly. (When
lens and Gear are attached to the camera pull Zoom/Focus Dial outward from housing to
disengage and ease actuation.
4. After performing O-ring Maintenance, carefully attach back cover as instructed in
OPENING AND CLOSING BACK COVER making sure nothing is caught between the
housing body and back cover.
5. After conducting proper O-ring Maintenance on the Housing Port and appropriate Lens
Port for the lens to be to be used, attach Lens Port to Housing Port as instructed below in
INSTALLING LENS PORT.
6. Fill a bucket with water and perform Pre-Dive Check. Immerse Housing (with Port
attached) several times, starting with short intervals, gradually lengthening time, checking
for water leakage after each interval.
7. When entering water use a method of water entry that protects the housing from shock,
which can cause water leakage. If at all possible have Housing handed to you after
entering the water.
REMOVING CAMERA
CAUTION! After use in water, water will remain in gaps between housing, back cover and
Secure-Latch. Wipe any water off housing with a soft dry towel to prevent water from falling
on camera.
1. If camera flash is deployed, close using the housing Flash Close Lever.
2. Open the back cover as instructed in OPENING AND CLOSING THE BACK COVER.
3. Carefully tip housing body backwards, gently sliding camera out.
INSTALLING LENS PORT
※
Please perform proper Housing Port and Lens Port O-ring and Contact Surface
maintenance. Failing to do so may result in leakage.
※
Please conduct the following operations in a clean area with low humidity and dust.
※
Recsea housings can be used with various Lens Ports and compatible with a variety of
lenses.
CAUTION! Only use the proper Lens Port intended for each lens. Failure to use the proper
Lens Port could result in image vignetting and distortion, as well as possible water leakage.
1. Place Lens Port over Housing Port with Lens Port Lock Tab aligned with housing's Lens
Port Mount Groove, above the Port Lock Button.
2. Place Lens Port over Housing Port with Lens Port Lock Tab aligned with housing's Lens
Port Lock Tab Groove, above the Port Lock Button.
3. Make sure the Lens Port is resting evenly on the Housing Port and then push down onto
the Housing Port.
4. With Lens Port evenly pushed down onto Port Mount, rotate Lens Port clockwise until the
Port Lock Button engages with an audible click.
REMOVING LENS PORT
CAUTION! After use in water, before removing Lens Port wipe any water off Housing and
Lens Port with a soft dry towel to prevent water from falling into the Housing and onto
camera.
※
NOTE: Lens Port cannot be removed with Strobe Mask-External Strobe Connection Mount
attached to the housing. Please remove first.
4.