Recsea CWP-TX70-MZ, Руководство пользователя

Страница: 10 / 13

2. Manipulate all buttons and dials several times to flush out salt deposits and other
contaminants.
3. Wipe any water off housing with a soft dry cloth.
4. Open Back Cover and remove camera.
5. Remove Lens Port.
6. Using the O-ring Removal Pick, remove O-ringss.
7. Clean O-ring groove and contact surfaces using a clean cotton swab. DO NOT clean
housing, Back Cover or Lens Port with volatile organic solvents or chemical cleaning
agents such as thinner, gasoline, and benzine, etc.
8. Perform O-RING GREASING & MAINTENANCE as instructed below before re-installing.
O-RING GREASING & MAINTENANCE ( 1)
※
CAUTION! DO NOT use silicone grease other than that provided by Seatool/Recsea.
1. Using the O-ring Removal Pick, remove O-ring.
2. Clean sand, salt, other contaminants and old grease from O-ring.
3. Clean O-ring groove and O-ring Contact Surface using a clean cotton swab.
4. Visually and physically check O-ring by running it through finger tips, feeling for cuts,
cracks or any other defects that may cause leakage. Such defects will cause water
leakage, so be sure to replace the O-ring. Be careful not to stretch or pull the O-ring too
much.
5. Squeeze a rice grain sized bead of silicone grease on your thumb and forefinger. Taking
care not to pull or stretch the O-ring too much, uniformly spread grease on O-ring. Too
little grease may cause the O-ring to twist in the groove, possibly causing water leakage.
6. Place O-ring in the appropriate O-ring groove, making sure that it is uniform, not twisted
or bulging out, possibly causing water leakage. When closing back cover, visually check
O-ring surface, tracing a finger over the to making sure no hair, lint or other contaminants
are attached.
IMPORTANT NOTES:
※
When housing and lens ports are not used for long periods, remove O-rings and place in a
plastic bag to keep the free of dust and other contaminants and store in a place out of
direct sunlight. Please also be careful of prolonged exposure to direct sunlight during use.
The O-ring and housing may become deformed, causing water leakage.
※
After extended periods of non-use, soak closed empty housing in lukewarm for half a day.
Manipulate all buttons and dials several times. Using a soft, dry cloth wipe away water.
CAUTION!
※
The O-ring is an essential part of waterproofing for this housing. Not properly greasing the
O-ring as directed may cause the O-ring to twist in the O-ring groove, possibly causing
water leakage.
※
Always perform the above O-ring, O-ring groove and O-ring Contact Surface maintenance
and greasing every time you open/close the housing.
※
Please pay close attention and make sure the O-rings are not twisted or bulging, free of
any contaminants (dirt, hair, etc.), and that foreign objects do not obstruct proper closing
of the housing Back Cover.
※
DO NOT clean the housing with volatile organic solvents or chemical cleaning agents such
as thinner, gasoline, and benzine, etc.
※
Housing Back Cover and Port Lens are manufactured using hard coat acrylic. When
cleaning use a clean soft cloth taking care not to scratch it.
INSURANCE INFORMATION
※
Seatool/Recsea strongly recommends insuring your camera. For more information please
contact your dealer.
8.