Record Power RPMSR, Инструкция по эксплуатации, Страница: 5 / 18

SAFETY IS A COMBINATION OF OPERATOR
COMMON SENSE AND ALERTNESS AT ALL
TIMES WHEN THE TABLE SAW IS BEING
USED.
WARNING: FOR YOUR OWN SAFETY, DO NOT ATTEMPT
TO OPERATE YOUR TABLE SAW UNTIL IT IS COMPLETELY
ASSEMBLED AND INSTALLED ACCORDING TO THE
INSTRUCTIONS.
SAFE OPERATION
1. The table saw should be bolted to the floor where possible.
2. If you are not thoroughly familiar with the operation of
table saws, obtain advice from your supervisor, instructor, or
other qualified person or contact your retailer for information
on training courses. Do not use this machine until adequate
training has been undertaken.
3. Never turn the machine ‘ON’ before clearing the table of all
objects (tools, scrap pieces etc.)
4. Ensure that:
(i) the voltage of the machine corresponds to the mains voltage.
(ii) To use an earthed power source (wall socket).
(iii) The cord and plug are in good condition, i.e. not frayed or
damaged.
(iv) No saw teeth are missing and the blade is not cracked or
split. Otherwise replace blade.
(v) The blade is aligned.
5. Never start the machine with the saw blade pressed against
the workpiece.
6. Never apply sideways pressure on the blade.
7. Care must be taken when cutting wood with knots, nails or
cracks in it and / or dirt on it.
8. Never leave the machine running unattended.
9. Do not use saw blades which are damaged or deformed.
10. Ensure the selection of the saw blade is suitable for the
material to be cut.
11. If the electrics are damaged, parts must only be replaced by
a qualified electrician.
12. Never use a long extension cable.
13. Always use a push stick and keep hands clear of the blade.
14. Never remove the crown guard or riving knife. These are
there to protect the user.
15. WARNING LABELS – It is important that labels bearing
Health & Safety Warnings are not removed or painted over. New
labels are available from Customer Services.
16. MECHANICAL SAFETY – The security of all clamps and
work holding devices should be checked before switching on.
17. WOOD DUST – The fine particles of dust produced in
cutting operations are a potential health risk. Some imported
hardwoods do give off highly irritant dust which causes a
burning sensation. We strongly recommend the use of a
dust collector and dust mask/visor. Our Customer Services
Department will also be happy to advise you on the correct unit
for your needs.
18. This machine falls under the scope of the ‘Health &
Safety at Work etc. Act 1974’, and the ‘Provision & Use of
Work Equipment Regulations 1998’. We recommend that you
study and follow these regulations. For further help on any
of the above matters please contact our Customer Services
Department at :-
Tel: 0870 770 1777 Fax: 0870 770 1888
WARNING: Do not allow familiarity (gained from frequent use of
your machine) to cause complacency. Always remember that a
careless fraction of a second is sufficient to inflict severe injury.
Additional Safety Instructions
For Table Saws
4 5