Record Power RPMSR, Инструкция по эксплуатации, Страница: 12 / 18

5. Router Table Assembly
- cont.
WARNING:
This appliance must be earthed -
failure to do so may lead to personal
injury. Always ensure your router is
correctly and fully earthed.
Electrical Information
The Router Table is supplied fitted with a
BS1363 three pin plug. The wires in the
mains lead are coloured in accordance
with the following codes-
Green and yellow - Earth
Blue - Neutral
Brown - Live
If a new plug is to be fitted
The green and yellow coloured wire must
be connected to the terminal, which is
marked with the letter 'E' or by the Earth
symbol
The blue coloured wire must be conected
to the terminal which is marked with the
letter 'N'.
The brown coloured wire must be
connected to the terminal which is
marked with the letter 'L'.
Machines for use in the U.K. are fitted
with a BS1363 13amp. 3 pin plug. Ensure
you use the correct plug for use in other
countries.
Replacing the power supply cable
A qualified electrician should carry out
replacement of the power supply cable.
R.C.D. (Residual Current Device)
For you additional safety, we always
recommend the use of an R.C.D.
(Residual current circuit breaker or Earth
leakage circuit breaker)
Power Switch Mounting
Rear view of switch box, Fig.3.1 showing
inlet for attachment of the power lead
from the router unit.
Start/Stop Switch on Router Unit
To enable the No Volt protection system
to function correctly, ensure that the
Start/Stop switch on the router is locked
in the Start position before mounting to
the table. Should any difficulties arise in
attempting this please contact your router
supplier for advice.
Fig.3.1