9
6. Assembly
Installing Tool Rest on to the Lathe Bed
Loosen locking arm and insert tool rest into tool rest base, adjust height as
required and tighten the locking arm.
Fig.6.1
.
Locking arm
Tool rest
Tool rest base
Fig.6.1
Fitting the 4-Prong Drive to the Headstock
Insert the drive centre, with a No.1 Morse Taper shank, into the headstock
spindle.
Fig.6.2
.
Drive centre
Headstock spindle
Fig.6.2
Fitting the Revolving Centre to the Tailstock
Insert the live centre, with a No. 1 Morse Taper shank into the tailstock
spindle.
Fig.6.3
.
Please note: Before inserting tapered attachments into the
headstock or tailstock spindle, always ensure that the taper
is clean and free of any waste material that may cause
misalignment or vibration. Always fully seat the taper by
tapping it squarely into place with a wooden mallet.
Live centre
Fig.6.3
Locking arm
Tailstock spindle
Fitting Tool Holder to the Lathe Bed
Locate the tool holder from the carton and install it onto the lathe bed
with two pan head screws.
Fig.6.4
.
Pan head screw
Tool holder
Fig.6.4
Secure Lathe to a Solid Work Surface
The lathe must be attached to a solid work surface or stand, not less than
25mm thick. Four mounting holes are easily accessible at the base of the
lathe.
Fig.6.5
.
Drill holes in the work surface, using a 1/2” or 13mm drill bit,
following the dimensions below.
Note: Use of the DML305/A Adjustable Stand is recommended.
670mm
165mm
Fig.6.5
Mounting holes
i
Kg
DML305-VS Manual 3.0.indd 9
19/09/2013 11:13
