Record Power 54100, Оригинальное руководство пользователя

Страница: 12 / 24

12
Performing Cuts
After selecting and installing the correct blade type and setting the correct
blade speed for the work, position the workpiece on the table.
Lower the drop foot on to the workpiece, so that it lightly rests on the
surface of the material. Secure the foot in position with the drop foot lock
knob,
Fig 8.16
, and lower the blade guard.
Take care to ensure fingers are kept clear of the blade whilst
using the scrollsaw. Ensure the blade guard and drop foot are
used during cutting.
Ensuring the material to be cut is not touching the blade, turn the power on
by pressing the green button marked ‘I’,
Fig 8.17
.
When the saw has reached the required speed, gently push the workpiece
into the blade to begin cutting. The speed can be adjusted by turning the
speed control knob as shown in
Fig 8.17 .
Please note: In general, harder and thinner materials require
finer saw teeth and higher speeds. Softer and thicker materials
generally require slower speeds. Please see the blade
manufacturer's instructions for further advice.
For cutting internal areas, first drill a hole through the area to be cut out.
Pass the blade through the hole as shown in
Fig 8.18 and re-attach the
blade to the upper holder. The internal area can now be cut.
Adjusting the Angle of the Table
Loosen the table locking knob, Fig 8.19 , to allow the table to be tilted.
Place a small try square on the table next to the blade to ensure it is
positioned at 90º to the blade as shown in
Fig 8.20
. If adjustment is
needed, turn the table until it is at 90º then securely tighten the table
locking knob.
After re-calibrating the angle of the table the degree scale pointer may also
need adjusting. Loosen the screw holding the degree scale pointer with a
Phillips screwdriver,
Fig 8.19 . Move the pointer to the 0º mark on the scale
and re-tighten the screw.
Please note: The scale is a guide only. If extremely accurate cuts
are required, perform practice cuts in scrap wood to determine if
your angle settings are correct.
Setting the Table for Horizontal or Bevel Cutting
Loosen the table locking knob in order to position the table between 0 and
45º and re-tighten once the table is in the desired position.
i
Kg
i
Kg
i
Kg
Fig 8.18
8. Operation
Fig 8.16
Fig 8.17
Variable speed
control On/Off switch
Fig 8.19
Table
locking
knob
Degree
scale
pointer
Fig 8.20
90º
SS16V Manual 4.0 (54100, 54101, 54102) 4.0.indd 12 10/09/2015 11:17