RM-216 CB.11 Easy Line Documentation
RDN 10000796
3
15.12.2014
1 Safety instructions
The filter control system RM-216 C when connected to the mains poses an electrical hazard.
Device failure, serious or even fatal injuries may occur as a result of improper installation of the
connected equipment. Consequently, follow in particular the points set out below in addition to
the general safety regulations for equipment in industrial electrical installations:
Installation of the device may be carried out only by qualified experts, in accordance with the
provisions of IEC 364, DIN VDE 0105 for electrical equipment.
All applicable laws, conditions, orders and regulations governing the setting up of electrical
equipment must be observed with respect to the installation site.
Setting of equipment with degree of protection IP00 without covers, may only be performed
by authorized expert staff, when disconnected, and whilst observing the local safety and
accident prevention regulations.
The RM-216 C may only be operated in the permitted operating area.
Switch off the mains supply before replacing the filter control or any components connected
to it. Otherwise the equipment may be damaged.
2 Equipment specification
The RM-216 CB is used to control 24 V DC solenoid valves on filtering separators with compressed air
pulse cleaning. After connecting the supply voltage, the filter control system functions fully automatically
without further activation.
